2013 GE Dash 4000 Patient M...
2013 GE Dash 4000 Patient Monitor (SPO2/ECG/NIBP/T/CO) – Parts/Repair ~ 38747
Item specifics
- For parts or not working
- Model
- Dash 4000
MPN- 2035598-203
Product details
Manufacturer | GE Medical Systems |
Item: | 2013 GE Dash 4000 Patient Monitor (SPO2 Oxiamx/ECG/NIBP/T/CO) – Parts/Repair |
Model/Cat # | Dash 4000 / Ref 2035598-203 |
Serial No. | SHQ13454397SA |
Made In: | USA |
Date of Manufacture: | 2013-11 |
Voltage: 100–120V AC 2.0A / 200–240V AC 1.0A, 50/60Hz
Short description:
GE Dash 4000 multiparameter patient monitor sold for parts or repair. The unit does not power on due to internal separation between the front soft-pad control interface and the LCD/back assembly. Right-side front bezel trim near the knob is cracked/pushed inward. Good candidate for refurbishment, parts harvesting, LCD swaps, chassis replacement, and parameter reuse.
Installed Parameters / Hardware Ports (Right Side):
- SpO₂ – Nellcor OxiMax Type
- Temp / Cardiac Output (CO)
- NIBP (Non-Invasive Blood Pressure)
- ECG (3/5-Lead)
Rear Panel I/O: Ethernet, AUX, Defib Sync
Printer Slot: Empty (printer not installed)
- Front bezel right-side near trim knob broken / pushed inward
- Handle intact
- Front LCD screen surface clean with no visible cracks
- Rear housing in very good cosmetic shape; no major cracks, dents, or structural damage
- Battery compartment is empty; rubber battery doors intact
- Side and rear labels readable
- No bottom stand/mount installed
- Device does not power on
- Internal ribbon or board connection between front soft buttons and LCD/back panel is disconnected, likely causing no-power condition
- Facility labeled unit “dysfunctional” before removal
- Facility reported LCD and parameters functioning before internal separation occurred
- Printer assembly not included / not installed
- Does NOT power on during testing
- No parameter testing possible
- Installed parameter ports appear physically intact
- LCD cosmetically good but not active due to internal disconnect
- All mechanical buttons, knob, and housing components intact except bezel trim
- Sold AS-IS / for parts or repair only
- GE Dash 4000 Monitor (main unit only)
- No SpO₂ sensor
- No ECG cable
- No NIBP cuff or hose
- No Temp/CO accessories
- No printer module
- No battery
- No power cord
- No mounting hardware / stand plate
- No user manual
*Items shown in photos are the items that will ship. If it is not shown in the photos, it is not included*
Stock ID : 38747 (P.O 4018) (WH104 SCC12)
Comments:
Kindly enlarge the images and see them with zooming.
Concern or query: Ask a Question
Condition: Parts Only, please refer to images for cosmetic condition.
- 1. Overall Condition: As seen in images : AS-IS
- 2. Physical Condition: Please review images before bidding : Fair
- 3. Working Condition: The unit does not power on due to internal separation between the front soft-pad control interface and the LCD/back assembly | The unit is being sold AS-IS / For Parts Use Only.......Will receive item as pictured…………(Offered AS IS)
- 4. “As a whole; the item has not been tested technically or professionally at our end- unable to test --- being sold STRICTLY AS IS! Biomed check is strongly recommended before clinical use!”
- 5. Completeness: (with everything seen in the pictures. Please look at all pictures and go through detail description before bidding.)